73 parts

[buckeye455]

have alot of 73 convertible spare parts , complete convertible top mechanism, body parts, engine455 400 thm trans, message me with anything you might need, i might have it ! thanks buckeye455

[wmarble]

I'm looking to replace the power seat motor for a bench seat for a 71 Centurion. Do you happen to have one?

[buckeye455]

I have the motors for power seat drivers side ,split seats though, not sure if they are the same or not? out of 73 centurion

[FIRE72DROPTOP]

Hi,

New to the site. Wondering if you might have the "CENTURION" fender emblem available? (I don't require the '455'). Also...rear driver's side tailight lens?

Abe
firefighter1968@hotmail.com
905.717.8149

[buckeye455]

i have both sides have to check condition of them,they are in storage right now buckeye455@hotmail .com

[FIRE72DROPTOP]

I take it you'll be looking for taillights. Or the emblem(s)? Either way - looking forward to hearing from you and thanks for your reply.

Abe
905.717.8149

[buckeye455]

tailight lenses , for a 73 centurion, still have to check on condition of them, thanks buckeye 455

[FIRE72DROPTOP]

Thanks. Looking forward.

[buicks4ever]

I'm looking for 1 Centurion fender emblem also. Lost the n somewhere :confused4: Thanks, Mark

[FIRE72DROPTOP]

I have an emblem however the 'n' has come free from the rest of the moniker (an easy fix in fact - epoxy or coldweld). That combined with double-sided tape should gett'er done. I purchased 1 off eBay for $145 plus shipping. I'm hoping to put my old one on eBay soon. I'm open to offers beforehand however.

Let me know.

abe

[Shrav]

have alot of 73 convertible spare parts , complete convertible top mechanism, body parts, engine455 400 thm trans, message me with anything you might need, i might have it ! thanks buckeye455

How is the drivers door?

[buckeye455]

sorry i dont have any doors thanks for your interest

[Critchie]

looking for drivers rear quarter glass, need a price asap.

[buckeye455]

sorry , already sold both quarter glass thanks for your interest

[SBRMD]

Looking for passenger side, the kind that only covers the rocker (not part of the set that continues up the door).

Thanks in advance,
Steve.

[72gsx4me]

Looking for left and right wide rocker moldings. The ones that have piece on door.

Any luck?

Thanks...:cool:

[buckeye455]

sorry, i dont have any rocker mouldings at all. thanks for your interest.

[JASON]

Buckeye

Do you still have some parts left? I am looking for a circuit board that would be contained in a plastic box inside the glove box (that is where it was on my 73) I had hopes that you might have a parts car and that is where your parts are originating from. I would be very interested in the circuit board and the box with wiring harnesses still attached if you have one.

Thanks for the possible help

[buckeye455]

thanks for the inquiry jason, what does the circuit board do? i have to check thru my parts , to see if i might have one, i will post after this weekend. thanks

[buckeye455]

jason , i do not have the circuit board your after,sorry buckeye

[garybuick]

I want to convert to power windows, I need everything. Also A/C conversion need everything. Seat belt housing and bolt covers, lower dash panel with screws, dash molding with air vents and emblem (dont need emblem if its missing).

[Buicken]

Do you have the Pinchwell molding ? (trim at back of rear deck, where top meets the body)

[73 CONVERT RON]

hi im looking for the rear bumper rubber for a 73 centurion i need the right and left sides can ya help ?? email me at potterypoor@aol.com or call 951-279-0353 thanks ron

[ponusa]

I need an engine wiring harness for a 71 buck centurion.
Do you have one?


ponusa@yahoo.com

[FIRE72DROPTOP]

I only have '72 Centurion parts - are you aware if the '71/'72 are inter-changeable?

[ponusa]

I am sure that is would be!!

[FIRE72DROPTOP]

I have a donor car that I just picked up ('72 Buick Centurion Convertible) however it's not here at home. I'm planning on going out there to start with the 'surgery' on Sunday. Evidently someone's (Gary Buick?) looking for power windows (glass, guides and motors?). I'll be needing the wiring harness from the donor car but I'd part with the 'replaced' one (has a few wires that have melted together but my elec. mechanic friend says it's not THAT bad. Bear with me.

[heavycenturion]

How about the quarter panels. Are they rusted?

[FIRE72DROPTOP]

HeavyC,

Rear quarters...unfortunately are the WORST thing on this donor car. Shot.

F72DT

[Mickemustang]

Hi
Do you have the Buick (letters) emblem for the trunk?

[FIRE72DROPTOP]

I'm unfamiliar with those...both my vehicles are from 1972. There are/were no "Letters". The only 'emblem' persay is the keyhole badge/frame.

[BuickLover]

Did you get that emblem. I may have one in my parts car.


Hi
Do you have the Buick (letters) emblem for the trunk?

[FIRE72DROPTOP]

The one I have is in very ruff shape.

[Mickemustang]

Did you get that emblem. I may have one in my parts car.

HI Buicklover,
No I still need the trunk emblem so if you have one im very interrested.
I also need a trim piece thats on right front fender. It´s actually runs along the whole right hand side but I just lack the front fender piece.

Let me post some photos here later on this day so theres no misunderstanding.

[Mickemustang]

Buicklover, heres what´s missing. The trunk needs the Buick Letter emblem.
It should have 2 pins on the back I beleive.

And both front fenders misses the trim piece that runs from backquarter panel and door to front fender.

If anyone has these parts in good shape I´m interrested of course.
:beers:

[BuickLover]

Do you happen to have the door panels? If they are in nice condition, what color are they. Mine are cream but the driver side is a little weathered.

Thanks,
BuickLover

[Mickemustang]

Sorry, don´t have any spare parts..

[72gsx4me]

BuickLover,

Don't know if you realize, but you are also missing chrome edge trim. There are 3 pieces on the trunk edge and 1 piece on each of the quarter extensions.


Will

[Mickemustang]

Will
I beleive that was an option when buying it new?!

[72gsx4me]

Buicklover,

The trunk lid moldings may be an option for 71 and 72 Centurions, but I think that the moldings were standard on 73s. Every 1973 Centurion that I have seen has had the moldings. The ones that don't are ones were ones that had them taken off or replaced with a stick on type.

Take a look at photos of members cars in 73 and almost everyone with photo has the trunk lid moldings.

If it was an option, I stand corrected. I defer to the rest of the forum.

Will:xyxthumbs:

[Mickemustang]

Ok, that seems right. Usually options becomes standard later on in production.
I think my centurion don´t have the original trunklid and perhaps thats why theres no crome around it. :confused:

[WDR]

Do oyu have the stainless trim for the trunklid?

[Shibbyman8787]

buckeye do you have a new dashboard? thanks shibby. also interested in your motor and trans. hubcaps? emblem? 858 414 8560

[Greg Duesler]

looking for a left door body side molding and a rear quarter lower molding for the right rear behind the tire. and a molding that goes on top of the left quarter panel where the convertable top comes down9IT IS MOUNTED ON THE TOP EDGE OF THE QUARTER BELOW THE WINDOW0 looking for a nice set of headlight doors and a nice rear bumper. and one back up light right rear.

[regalt87]

Looking for both fenders for 73 limited. What years will fit and do you know where I can find them? Thanks Scott. 8635576990

[heavycenturion]

Regal,

Sorry,

The fenders were sold some time ago.

Sorry!
Dennis

[regalt87]

Thanks.

[Bumble]

I have the quarter glass, fact. tint. $50. plus shipping.. John 206-920-2233

[racerjms]

Do you have the front bumper trim that goes across the bumper from drivers side to passenger side as well as any chrome trim in good condition? Thanks